01 · Define
Build the machine template
Machine safety pre-start for pack-line assets — e-stop fails raise a work order.
Manufacturing
One machine template. One fail. One owned fix.
Define Machine safety pre-start for pack-line assets, run it on PB-12, turn an e-stop fail into WO-2026-3301, close with proof — then see Line 3 risk in analytics.
- 02 · Inspect
Run it on PB-12
Same checklist every shift on Line 3 Pack — photo and note on the fail.
- 03 · Own it
Raise the work order
Needs repair opens WO-2026-3301 with owner, priority, and evidence attached.
- 04 · Close it
Fix with proof
Technician closes with root cause and resolution — trail stays audit-ready.
- 05 · See it
Plant analytics
Overdue work, repeat assets like PB-12, and completion vs target by site.
01 · Define
Build Machine safety pre-start once.
Same template for every pack-line asset. Sections for line guards and controls, response types that require photo and note on fail, and logic that raises a work order — not a PDF.
- ASSET template · Pack line type
- E-stop / guard interlock → Needs repair creates work
- Drag-and-drop builder with conditional follow-ups
02 · Inspect
Run it on PB-12 · Line 3 Pack.
Operators open the checklist that belongs to that machine. Mark E-stop / guard interlock as Needs repair, attach the evidence photo, and leave the note — online or offline.
- Question: E-stop / guard interlock
- Answer: Needs repair + note + photo
- QR / asset entry so the right template opens
03 · Own it
That fail becomes WO-2026-3301.
The failed e-stop answer raises a work order with inspection context attached — High priority, assigned to maintenance, evidence photo on the trail — so Line 3 is not waiting on a clipboard.
- Title: E-stop / interlock fault — Line 3 Pack
- Owner Priya · due before next shift
- Same guard photo that was captured on the check
04 · Close it
Fix the interlock. Close with proof.
Diego completes the repair with root cause and resolution. The work order closes completed — same PB-12 asset, same e-stop fault, audit trail intact for the next shift.
- Root cause: Failed switch / wiring
- Resolution: Repaired wiring / switch
- Line released after hard-stop verified
05 · See it
See Line 3 and PB-12 in the rollup.
Completion vs target, overdue tasks by site, and assets going down most frequently — so repeat e-stop faults on PB-12 show up before the next stoppage.
- Completion / closure rate with KPI target
- Overdue work by Line 3 Pack and sister sites
- PB-12 Pack press in the repeat-asset table
Built for the plant
Same standard for operators, maintenance, and plant leads.
From the Machine safety pre-start template to PB-12 close-out and Line 3 analytics — one trail, online or offline, without a spreadsheet stack.
Ready to modernize your inspections?
Start free — set up your organisation in minutes.